Previous image Up to current index page (1) Next image A bit of hot-melt glue helps keep things in place for the long haul, yet can be peeled away easily when needed. Be careful not to get it on any of the empty pins! Not suitable for very hot climates, though fine in Ottawa. A late addition: inline fuse between the power (from Reverse Lights) and the rest of the wiring. I used a 0.5A fuse, though anything up to about 1.0A should be fine. The camera wiring in the hatch uses the clips conveniently provided from the factory, with a bit of foam tape (weatherstripping) wrapped around the cabling to prevent rattles. Looks nice. White on white. The camera was mounted by drilling a 15/64" hole through the plastic at the "cut out" markings intended for the factory camera. The camera is mounted parallel with the face line of the cut-out, giving the best orientation for aligning the Subaru on-display guide lines. And the colour match is much better than it appears in this photo.
Back to first image Up to first index page Skip to final image
Previous group of thumbnails Hide thumbnails Next group of thumbnails
Reduce image size Enlarge image size
The camera wiring in the hatch uses the clips conveniently provided from the factory, with a bit of foam tape (weatherstripping) wrapped around the cabling to prevent rattles.
The camera wiring in the hatch uses the clips conveniently provided from the factory, with a bit of foam tape (weatherstripping) wrapped around the cabling to prevent rattles. (z0612023)
z0612023 (11/20): Canon-7D ISO200 1/250 f11.0 Auto-WB 26mm (18-250mm) flash+0EV 2014-04-09 16:20
Use the magnify icons (above) to change the image size