Previous image Up to current index page (1) Next image Back to first image Up to first index page Skip to final image Reduce image size Show thumbnails
Cut a hole for the switch, a notch for the cord, and hot-glue the GPS into place, antenna side up! Twist the cabling around and hot-glue the Arduino and the cable, holding them in place while the glue hardens.

Note that I attached everything but the switch to the underside of the box lid, so that it is all accessible for future re-programming if need be.
Cut a hole for the switch, a notch for the cord, and hot-glue the GPS into place, antenna side up! Twist the cabling around and hot-glue the Arduino and the cable, holding them in place while the glue hardens.Note that I attached everything but the switch to the underside of the box lid, so that it is all accessible for future re-programming if need be. (project_installed)
project_installed (17/20):
Use the magnify icons (above) to change the image size